Sony FWD-50PX1 - Manual (Page 61)

11
(GB)
Location and Function of Parts and Controls
Remote Commander RM-980C
1 POWER ON switch
Press to power on the display.
2 STANDBY button
Press to change the display to the standby mode.
3 MUTING button
Press to mute the sound. Press again to restore sound.
4 DISPLAY button
Press to show the on-screen information on the current
input signal, Picture Mode, and so forth. Press again
to hide them.
If this displayed information is left undisturbed for a
short time, it will disappear automatically.
5 INPUT1 button
Press to select the signal input to the INPUT1
connectors. Each press toggles between RGB and
COMPONENT.
RM-980C
MONITOR
INPUT1 INPUT2 OPTION
PICTURE ASPECT MENU
ID MODE
MUTING DISPLAY STBY ON
ENTER
SET ON OFF
0
8 7 9
5 4 6
2 1 3
2
1
3
qa
5
4
7
6
8
9
0
qs
qd
qh
qg
qj
qf
6 INPUT2 button
Press to select the signal input to the INPUT2
connectors. Each press toggles between RGB and
COMPONENT.
7 PICTURE button
Selects Picture Mode. Each press toggles between
Standard, Vivid and User 1 to 3.
8 ASPECT button
Press to change the aspect ratio (Wide Mode).
9 M/m/</,/ENTER buttons
The M/m/</, buttons move the menu cursor
(yellow) and set values, etc. Pressing the ENTER
button sets the selected menu or setting items.
q; Number buttons
Press to enter index numbers.
qa BRIGHT button
Adjusts the brightness when Picture Mode is set to
any of “User1” to “User3.” Press this button, then
adjust the brightness with
M/m or </, buttons 9.
qs ID MODE (ON/SET/OFF) buttons
Press ON to show an index number on the screen.
Enter the index number of the display you want to
operate with Number buttons 0, then press SET.
Press OFF to return to the normal mode.
qd VOLUME +/– button
Press to adjust the volume.
qf OPTION button
When an option board is installed, selects a signal to
be input from the device connected to the option
board. Each press toggles between the signals.
qg MENU button
Press to show menus. Press again to hide them.
qh CHROMA button
Adjusts the chroma when the Picture Mode is set to
any of “User1” to “User3.” Press this button and
adjust the chroma with the
M/m or </, buttons 9.
qj CONTRAST +/– button
Adjusts the contrast when Picture Mode is set to any
of “User1” to “User3.”
* Unusable. You cannot control the display unit using these
buttons.