Sony FWD-50PX1 - Manual (Page 77)

27
(GB)
Watching the Picture
Input Signal, Picture Mode and
Display Status Information
Input signal and Picture Mode information is appears
on the display panel for about five seconds when the
power is turned on or when switching the input signal.
To disable this function, follow the steps below.
1
In the Custom Setup menu, press M/m to move the
cursor (yellow) to “Display” and press ENTER.
The following menu appears on the display panel.
P o w e r S a v i n g : S t a n d a r d
S p e a k e r O u t : O n
C l o s e d C a p t i o n :
D i s p l a y :
S c r e e n S a v e r
C o l o r M a t r i x
H D M o d e :
R G B M o d e : P C
C u s t o m S e t u p
, t o s e l e c t , p r e s s ENTER
t o r e t u r n
O n
O f f
2
Press M/m to set Display to Off and press
ENTER.
To display the information
Set Display to On in step 2 above. The factory default
is On.
Note
You can display the input signal information and the
time anytime by pressing the DISPLAY button on the
Remote Commander, regardless of the above setting.