Sony FWD-50PX1 - Manual (Page 94)

44
(GB)
Self-diagnosis Function
The unit has a self-diagnosis function.
This function shows the display’s condition based on
the pattern shown by the flashing of the POWER/
STANDBY indicator. The flashing pattern informs
you of the display’s current condition.
If the POWER/STANDBY indicator flashes, check
the number of flashes and contact your authorized
Sony dealer.
1
Check the flashing pattern of the POWER/
STANDBY indicator.
The indicator flashes (with an image showing on
the display) or flashes at intervals of three seconds
(with no image showing on the display).
Count the number of flashes if the indicator
flashes at intervals of three seconds. For example,
the indicator flashes twice, followed by a three
second pause, two more flashes and this pattern
repeats. In this case, the count for the number of
flashes is two.
2
Unplug the unit.
Inform your authorized Sony dealer of the number
of flashes.
Power Saving Function
1
In the Timer/Clock menu, press M/m to move the
cursor (yellow) to “Auto Shutoff” and press
ENTER.
The following menu appears on the display panel.
T i m e r / C l o c k
C l o c k S e t
C l o c k D i s p l a y : O f f
O n / O f f T i m e r : O f f
A u t o S h u t o f f :
, t o s e l e c t , p r e s s
t o r e t u r n
ENTER
O f f
5 m i n
1 0 m i n
2
Press M/m to select the length of time until the
change to power saving mode.
Off : The power saving function does not work.
5min : Changes to the power saving mode after
five minutes if there is no input signal.
10min : Changes to the power saving mode after
ten minutes if there is no input signal.
When the power saving mode is on, the unit
changes to standby mode.
Note
The power saving function is available only when a
video signal or a component signal is being received.
When RGB is selected and the display receives no
RGB signal for more than 30 seconds, the display
enters the standby mode and the POWER/STANDBY
indicator lights up in orange. Once an RGB signal is
input to the selected INPUT, the power is
automatically restored and the picture shows on the
screen. (PC power saving mode)
To cancel the power saving function
Press the 1 (POWER) switch on the Control Button
section or the POWER ON switch on the Remote
Commander.
Controlling Power On/Off Automatically (Timer Function) /Self-diagnosis Function