Sony DCR-IP5 - Manual (Page 32)

32
Adjusting the brightness of the LCD screen
When recording in bright conditions, set the LCD BACKLIGHT switch to OFF.
(1) In CAMERA, MEMORY (DCR-IP7BT only), playback, or playback pause
mode, select FN, then press the center z on the control button. The PAGE1
screen appears.
(2) Select PAGE2, then press the center z on the control button. The PAGE2
screen appears.
(3) Select LCD BRT, then press the center z on the control button. The screen used
for adjusting the brightness of the LCD screen appears.
(4) Select –/+, then press the center z on the control button repeatedly to adjust
the brightness.
– : to dim
+: to brighten
You can also adjust the brightness by pressing b/B repeatedly after you select
–/+.
(5) Press DISPLAY to clear the screen buttons.
To return to the FN screen
Select OK, then press the center z on the control button after step 4. The PAGE2
screen appears. Next, select EXIT, then press the center z on the control button.
When FN is not displayed on the screen
Press DISPLAY or z so that FN is displayed. You can also use DISPLAY on the Remote
Commander.
1 3,4
FN
2
5
LCD
BRT
PAGE2
LCD BRT – +
OK
Recording a picture
OPEN
LCD BRT bar