APPLIED ENGINEERING RamKeeper - Manual (Page 16)

7.) Both of the wires that lead to the GelICell should
be disconnected. If they aren't, disconnect them
now.
Disconnect the battery wires
8.) Remove the RamKeeper from its anti-static bag.
Hold the card by its edges, like a photograph.
9.) Connect your card or cards according to the
instructions below. Refer to the illustration
below for the proper connector and placement of
your card(s).
Slot Mover RamKeeper
All GS -RAM cards Back Pocket
(including 2 Meg Expander) GS -RAM REV C or later
Apple II GS Memory Expansion Card GS -RAM Plus REV D or later
RamPak 4 GS GS -RAM 2 Meg Expander
RamStackPlus Apple II GS Memory Expansion Card
OnBoard RamPak 4 GS
OctoRam Front Connector RamStackPlus
All GS -RAM cards On Board
(except 2 Meg Expander) * Due to its large size,
OctoRam will not fit on the
back side of RamKeeper
RamKeeper Connections
Chapter One - Getting Started 7