APPLIED ENGINEERING RamKeeper - Manual (Page 22)

11.) Install the connector plate using the screws
provided. Line up the holes of the connector
plate with the notches at the top and bottom of
the opening in the backplane. Insert and tighten
the screws using the hex wrench provided.
Attach connector plate to backplane
12.) If you’re installing a card into the Back Pocket, do
so now by lining up the fingers of the memory
card’s edge connector with the Back Pocket’s slot
and using the heel of one hand to seat the card
firmly.
13.) Insert the insulator sheet included with
RamKeeper between the back of the RamKeeper
and the right side of the computer case. Slide the
insulator as far toward the keyboard end as
possible.
Even if you aren’t using the Back Pocket or the
Flex Connector, insert the insulator. This way,
you’ll know where it is when you expand in the
future.
Chapter One - Gelling Started 13