APPLIED ENGINEERING RamKeeper - Manual (Page 24)

16.) Reconnect the battery cables to the GelICell’s
connectors. The green LED light on the
RamKeeper should come on. This indicates that
your battery is working. If it doesn’t come on
immediately, it is because it needs to be refreshed
after its journey from our hands to yours.
Continue with the installation and the
Transformer will trickle charge the battery back to
its full potential within 24 hours.
17.) Plug the transformer into a wall outlet. This wall
outlet should be independent of wall switches
and dimmer switches. If you must use a switch
controlled outlet, make sure the switch remains
on.
18.) Check the LED lights to make sure the
transformer is functioning. Both lights should be
on. If they are not both on, check the
transformer’s connections.
19.) Replace the Apple's cover. You may need to
guide the insulator inwards as you close the
cover.
20.) Hardware installation is complete. Now you’ll
need to set up your ROM Disk with the firmware.
The Double Boot
When using certain configurations with RamKeeper,
your GS will beep twice when you boot it. The first beep is
normal power up. The second is RamKeeper installing
itself and resetting the computer. Some configurations do
not require the double boot.
Chapter One - Getting Started 15