APPLIED ENGINEERING RamKeeper - Manual (Page 20)

Attaching the Optional SlotMover
The SlotMover is an extension board that shifts the
expansion board on the front side of the RamKeeper so
that it wont block slot 7. (Slot 7 is commonly used for
hard drive controller cards.)
Its new position is between slots 4 and 5. Because 4 is the
mouse port and 5 is the disk drive port, you’ll probably
never want to put a card in either.
A) First, lay the RamKeeper face up on the table.
B) Notice the white pegs in two holes of the
RamKeeper’s front connector. (See picture on
page 8.)
C) Push the SlotMover pins into the holes between
these two pegs.
Insert SlotMover into connector
D) Push until SlotMover pins are completely seated
Don’t insert a card in the SlotMover until you have
plugged RamKeeper into the Memory Expansion Slot.
Chapter One - Getting Started 11