Alpine INA-W900 - Manual (Page 55)

53
-EN
The clock indication on the monitor display is turned on or off
respectively.
Setting item: Clock
Setting contents: OFF / ON
• The clock of the unit will be automatically updated according to the
data that the Navigation System provides, and cannot be adjusted
manually.
• If the GPS antenna is not connected correctly, the clock indication on
the unit may be wrong because the time information cannot be
received. In this case, it is suggested to set “Clock” to “OFF”.
Setting item: Beep
Setting contents: OFF / ON
Scroll display is available if CD text, folder name, file name or tag
information is entered.
Setting item: Auto Scroll
Setting contents: OFF / ON
• The display scrolls on the unit when the screen is filled up.
• Song, artist and album name, etc. scrolls when an iPhone/iPod is
connected.
• Short/Long Station name, Song, Artist, and album name scrolling are
displayed in HD Radio mode.
You can adjust the brightness of the button lighting at night with the
dimmer.
Setting item: LED Dimmer Level
Setting level: -2 to +2
System Setup Operation
1
Press SOURCE/ on the unit.
The SOURCE selection screen is displayed.
2
Touch [ ] on the main source screen.
The SETUP main screen is displayed.
3
Touch [ ] of System Setup.
The System Setup screen appears.
4
Touch [ ] or [ ] etc., of the desired item to change
its setting.
Setting items:
IN Int. Mute
*1
/ IN Int. Icon / Remote Sensor
*2
/ Camera IN / AUX
IN / AUX IN Level
*3
/ AUX IN Signal
*3
/ AUX OUT / BLUETOOTH
IN / AUX+ IN / AUX+ Level
*4
/ Rear Source
*2
*1 Displayed only when BLUETOOTH IN is OFF.
*2
Displayed only when AUX OUT is ON.
*3
Not displayed when OFF is set in “Setting the AUX Mode”
(page 55).
*4
Not displayed when OFF is set in “Setting the AUX+ Mode”
(page 55).
5
Touch [ ] to return to the previous screen.
Touch [ Exit ] to return to the main source screen that was
displayed before the setup operation was started.
• Immediately after changing the settings of System Mode (while the
system is writing data automatically) do not turn the ignition key
(engine key) to OFF. Otherwise, the settings may not be changed.
Displaying the Time
Sound (Beep) Guide Function
OFF: Deactivate the Sound Guide mode. The sound guide
beep will not be produced when a button on the unit is
pressed.
ON: Activate the Sound Guide mode.
Setting the Scroll
OFF: Turns off the AUTO scroll mode. Scroll display is done
once as a track is changed.
ON: Turns on the AUTO scroll mode. Scroll display is
repeated as long as the mode is turned on.
Adjusting the Dimmer of Button Lighting at
Night
SYSTEM Setup
To display the System mode screen:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedures below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the System mode operation has been
released. Engaging the parking brake can reactivate the System
mode, as long as the car’s ignition has not been turned off. It is
not necessary to repeat the above procedure (1 through 3) of “To
display the System mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To
display the System mode screen.”
The following steps 1 to 5 are common operations to each
“Setting item” of SYSTEM Setup. Refer to each section for
details.