Panasonic RRXS350E - Manual (Page 46)

46
Troubleshooting guide
Symptom Checkpoints
Recording
Recorded sound is distorted.
There is a noise at the
beginning of sound.
• Lower the microphone sensitivity (➜ page 17) or move further away from the
recording sound source.
If the sound is still distorted, set the LOW CUT FILTER to ON (➜ page 17)
before recording.
Recorded sounds contain
noise that make it difficult to
hear sounds. • Move a mobile telephone away from this unit when you use the two in the
same area.
• Set the LOW CUT FILTER to ON. Noise is reduced and listening may become
easier. (➜ page 17)
• Set the optimal recording settings by changing the sound quality (➜ page 16)
and microphone sensitivity (➜ page 17) and performing trial recordings.
Recorded sound is too loud or
too low. • Switch the microphone sensitivity. (➜ page 17)
Cannot perform timer
recording. • Is there sufficient space in the memory?
• 199 recorded files (maximum recordable number) may be present in the folder.
If the folder contains 199 recorded files, no more files can be recorded.
• The unit cannot be operated when connected to a computer. Remove it from
the computer.
• If another recording is in progress even if the timer recording start time comes,
the current recording is prioritised. Stop the recording. However, if you are
using the unit for operations other than recording, the timer recording is
prioritised.
• Timer recording does not start if the recording destination was set to an SD
card and the SD card was removed before the start time.
VQT4J69
46
VQT4J69_RR-XS350_E_En.indd 46 VQT4J69_RR-XS350_E_En.indd 46 2012/05/25 11:48:07 2012/05/25 11:48:07