AT&T E1828B - Manual (Page 15)

12
Telephone operation
Handset settings
Set handset ringer tone
This feature allows you to choose one of 4 ringing
tones (1-4) or turn the ringer off. Use CID/-VOLUME
or DIR /VOLUME+ button to hear an example of
each ringer tone, then press SELECT/ TRANSFER to
select the one you prefer.
• Press MENU
/CHAN
to begin programming.
• Press CID/-VOLUME or DIR /VOLUME+ until
the screen displays RINGER: and setting.
• Press SELECT/
TRANSFER
to change current set-
ting.
• Press CID/-VOLUME or DIR /VOLUME+ to
display 1, 2, 3, 4, or OFF. You will hear a sample
of each ringer tone.
• Press SELECT/ TRANSFER to select the displayed
ringer tone and exit.
Set handset ringer volume
• Press and hold CID/-VOLUME or DIR /VOLUME+
for about two seconds.
• When the screen displays OFF LOW HIGH,
the current setting will flash.
• Press CID/-VOLUME or DIR /VOLUME+ to
select your preference.
• P re s s SELECT/
TRANSFER
, OFF/
CLEAR
,
or MENU/
CHAN
to confirm and save your
selection, and exit to idle mode.
NOTE: The cordless handset can be temporarily muted
by pressing OFF /CLEAR during incoming ringing. The
next call will ring normally.
RINGER: 1
OFF LOW HIGH
NOTE: If you choose OFF,
the cordless handset ringer will
be turned off, and the screen will
display RINGER OFF and when
the cordless handset is idle (not
in use). If there are any un-
reviewed calls, the screen will
displays XX MISSED CALLS
instead of RINGER OFF and .