Scpi command summary – Agilent Technologies 6028A User Manual
Page 111
Standard Commands for Programmable Instruments (SCPI)
111
Table C-5. Summary of Error Messages (continued)
Error Number
Error String [Description/Explanation/Examples]
-178
Expression data not allowed
-180
Macro error
-181
Invalid outside macro definition [e.g., ’$1’ outside macro definition.]
-183
Invalid inside macro definition
-184
Macro parameter error
- 200
Execution error [generic]
- 220
Parameter error
- 221
Settings conflict [uncoupled parameters]
- 222
Data out of range [e.g., too large for this instrument]
- 223
Too much data [out of memory; block, string, or expression too long]
- 240
Hardware error
- 241
Hardware missing
- 270
Macro error
- 272
Macro execution error
- 273
Illegal macro label
- 276
Macro recursion error
- 277
Macro redefinition not allowed
- 310
System error
- 313
Calibration memory lost [out of cal due to memory failure]
-330
Self-test failed [more specific data after ";’’]
- 350
Too many errors [error queue overflow]
- 400
Query error
- 410
Query INTERRUPTED [query followed by DAB or GET before response complete]
- 420
Query UNTERMINATED [addressed to talk, incomplete programming message
received]
- 430
Query DEADLOCKED [too many queries in command string]
- 440
Query UNTERMINATED [after indefinite response]
SCPI COMMAND SUMMARY
This summary lists all power supply subsystem commands in alphabetical order, followed by all common commands in
alphabetical order. See Table 3-7 in Section III for the numerical parameters for each model of the Agilent Series 603xA
power supplies. Table C-6 is a cross reference to the corresponding ARPS commands in Table 3-7.
Command Summary
Subsystem Commands
Command
Parameters
ABOR
(none)
[SOUR]:CURR[:LEV][:IMM][:AMPL]
<space> <NRf+ >[suffix]
[SOUR]:CURR?
(none) or <space>MlN or <space>MAX
[SOUR]:CURR[:LEV]:TRIG[:AMPL]
<space> <NRf+ >[suffix]
[SOUR]:CURR[:LEV]:TRIG?
(none) or <space>MlN or <space>MAX
[SOUR]:CURR:PROT:STAT
<space>0 or OFF <space>1 or ON
[SOURl:CURR:PROT:STAT?
(none)
INIT[:IMM]
(none)
INIT:CONT
< space > 0 or OFF or < space > ON
INIT:CONT?
(none)
MEAS:CURR[:DC]?
(none)
MEAS:VOLT[:DC]?
(none)