Panasonic -eng User Manual
Page 98
98
When a problem occurs - Copy -
Settings/Convenient information
Copy
When the following problem occurs
Confirm the following
The video camera is connected but not
displayed on the screen or recording
fails.
z If the video camera has not been set for connection with the PC, it will not be displayed.
(For details, refer to the operating instructions for the video camera.)
z Some video cameras are not supported by Windows
®
2000.
z If a video camera is connected that does not support the recording of images from a
PC, the video camera can be used only for reading data from media, but not for
recording data. (It is not displayed as the recording destination.)
An SD card is connected but not
displayed on the screen.
z An SDHC memory card (4 GB to 16 GB) will not be displayed unless using a
reader/writer that supports SDHC.
An error message is displayed when
selecting the destination.
z Close any other software using the drive.
z An error message may be displayed when a disc is replaced. Select the drive again.
z Other recording software may be interfering with the operation. In this case, uninstall
the other recording software.
The DVD disc is displayed as not being
supported.
z Before copying the DVD-RW/R/R DL (dual layer on single side) disc in the AVCHD
standard recorded by video camera, the discs must be finalized with the video camera
used for the recording.
Cannot record even though the
DVD-RAM disc is new.
z Commercially available DVD-RAM discs are initialized (formatted) in UDF 2.0 format so
it is necessary to format them on this software in UDF 2.5 format.
Cannot record on the card or disc after
formatting it using Windows
®
Explorer.
z It is necessary to format the DVD disc on this software before using it.
SD cards must be formatted with the video camera that this software supports
.
z It is impossible to use a DVD disc formatted in UDF 2.5 using any application other than
this software (for instance Windows
®
Exlorer).
HDWriter25_eng.book 98 ページ ２００７年１２月２６日 水曜日 午後５時４７分