Abt VP30 - Manual (Page 12)

8
Power/Standby Buttons
The iscan Vp30 remote has a power and a standby button. The power button always turns the
iscan Vp30 on and the standby button always put the unit into standby mode.
Curtain Button
The iScan VP30 remote has a Curtain button which allows you to close a ‘curtain’ over the image.
This feature is especially useful when an image is paused on a display susceptible to burn-in.
Remote Control Battery Installation
The remote control for the iscan Vp30 requires two aaa batteries. These should be replaced as
needed. abT recommends alkaline batteries because they last longer without leaking.
To install the remote control batteries:
. locate the battery compartment on the back of the remote control.
2. Remove the cover from the back. To do this, press the tab attached to the cover and
pull the cover with the guide on the back of the remote control.
3. Remove the old batteries (if applicable).
4. insert two new aaa batteries in the compartment as shown on the inside of the battery
compartment. Make sure the batteries are correctly inserted, observing the proper
polarity.
5. After installation, replace the cover and dispose of the old batteries (if applicable).
Menu Navigation
You can control the iScan VP30 as follows:
• from the front panel controls
• from the iscan Vp30 remote control
• from a programmed universal remote control
• using the serial connection on the back panel
The menu navigation controls on the remote control are duplicated on the front panel of the iscan Vp30.
To navigate the menu:
. press the Menu button.
2. use the directional buttons to highlight the parameter you want to change.
3. press the Enter button to select the parameter and the Left and Right arrow buttons
to change the chosen parameter.
4. press the Exit button to exit out of the menu/OSD.
Info Screen
press the Info button to display a window that shows information about the system including:
input status
Video source
signal Type
audio source
Aspect Ratio (Frame/Active)