Abt VP30 - Manual (Page 14)

0
s e C T i o n 3 – s e T u p
Initial Set-Up
Once you have installed the iScan VP30 into your system, you must properly configure it for the display
device being driven. The iScan VP30 is shipped from the factory with the following preset default settings:
• Input Select is set to AUTO, to automatically detect an active input in a pre-configured priority.
• The Digital Video output is selected with RGB 4:4:4 color space
• The output format is set to ATSC (DTV) 480p
use either the remote control or the front panel controls to perform the initial setup of the iscan’s
output. The procedure below uses the front panel buttons to perform initial setup.
Accessing the iScan VP30’s OSD is crucial, not only in allowing you to navigate the menu of the iScan
VP30, but also to let you know that the iScan is sending a compatible signal to the display. If the OSD is not
visible on the display’s screen when you press one of the sub-menu buttons on the remote control, then
you must configure the iScan with the Output Setup menu to output a signal that the display can accept.
Use these steps to allow you to see the OSD.
STEP 1 - Power Up
. attach the removable power cord to the external power supply.
2. Plug the removable power cord into a wall outlet or power conditioner, if applicable.
3. plug the small connector attached to the cable that comes out of the power supply into the
iscan Vp30.
The iScan VP30 should power on and display ‘DVDO iScan VP30 Powered by ABT’ on the FPD.
STEP 2 - Connect the iScan VP30 to your system
Displays with a DVI or HDMI Input
The default output on the iScan VP30 is digital RGB 4:4:4 (DVI Standard). If you have changed this
setting, follow these instructions to change the settings back.
. press the Menu button on the front panel of the iscan Vp30 once. You should see
‘ Main Menu /Input Select’ on the FPD.
2. press the Up button once. You should see ‘Main Menu / Output Setup’ on the FPD.
3. press the Enter button. You should see ‘Output Setup / Analog/Digital’ on the FPD.
4. press the Enter button. You should see ‘Analog/Digital / BNC (Analog)’.
5. press the Down button to select ‘HDMI (Digital)’ and press the Enter button.
You should see the iScan VP30’s On Screen Display (OSD) on your screen.
Displays with a Component (YPbPr) Input
. press the Menu button on the front panel of the iscan Vp30 once. You should see
‘Main Menu / Input Select’ on the FPD.
2. press the Up button once. You should see ‘Main Menu / Output Setup’ on the FPD.
3. press the Enter button. You should see ‘Output Setup / Analog/Digital’ on the FPD.
4. press the Enter button. You should see ‘Analog/Digital / BNC (Analog)’. If you don’t,
press the Up button once and the press Enter. You should see ‘Output Setup / Analog/
digital’ on the fpd.