Abt VP30 - Manual (Page 8)

4
Component video inputs that are not capable of accepting a 480p signal should be labeled ‘480i’
(NTSC) or ‘576i’ (PAL/SECAM).
The following types of displays should be compatible with an iScan video processor since a large majority
of them can support higher resolution signals:
• plasma displays
• LCD-based flat panel and front & rear projection displays
• DLP-based front & rear projection displays
• LCoS-based front & rear projection displays (D-ILA™ & SXRD™ included)
• CRT-based Direct View HDTVs and Computer Monitors with front and rear projection displays
Installation Guidelines
Take special care with the iscan Vp30 installation to ensure optimal performance. pay particular attention
to the bulleted items that begin below and to other precautions that appear throughout this guide.
Do . . .
• Install the iScan VP30 on a solid, flat, level surface such as a table or shelf. You can
also install the iscan Vp30 in a standard 9” equipment rack using an optional
rack-mount kit available from authorized DVDO resellers or directly from DVDO.
• Select a dry, well-ventilated location.
• use only the included external power supply.
• Avoid excessive humidity, sudden temperature changes or temperature extremes.
• Use only accessories recommended by the manufacturer to avoid fire, shock or other
hazards.
• unplug your iscan Vp before cleaning. use a damp cloth for cleaning.
Don’t . . .
• install the iscan Vp30 on an unstable surface or one that is unable to support all four of
its feet, unless it is installed in an equipment rack.
• Stack the iScan VP30 directly above heat-producing equipment such as power amplifiers
or other components that generate heat during use.
• Expose the iScan VP30 to a high temperatures, humidity, steam, smoke, dampness,
or excessive dust. avoid installing the iscan Vp30 near radiators and other heat producing
appliances.
• Install the iScan VP30 near unshielded TV or FM antennas, cable TV decoders, and other
RF-emitting devices that might cause interference.
• place the iscan Vp30 on a thick rug or carpet or cover the iscan Vp30 with cloth.
This might prevent proper cooling.
• Attempt to service this unit. Instead, disconnect it and contact your Authorized DVDO
reseller or contact anchor bay Technologies directly.
• Open or remove unit panels or make any adjustments not described in this manual.
Attempting to do so could expose you to dangerous electrical shock or other hazards.
it may also cause damage to your iscan Vp30.
• obstruct the front panel ir receiver window shown in “remote Control overview”.
do not attempt to use the remote control out of line of sight with the ir receiver.
doing so will cause improper operation.