Abt VP30 - Manual (Page 25)

2
Input Level
The input level setting allows the user to specify the levels of the input signal, either Video (16-235)
or PC (0-255)
• Video
• pC
VCR Mode
VCr Mode decouples the output timing completely from the input timing to ensure a stable output
from the iScan VP30 for VCR playback especially during trick-play modes (play forward, play reverse,
still/pause).
• On – output timing is decoupled from the input timing regardless of frame rate settings.
• Off – output timing is dependent on frame rate settings.
• Auto - Turns on VCR Mode if a VCR source is detected.
Film Mode
Film Mode allows you to control the film mode operation of the iScan VP30. Usually the automatic film
mode detection is preferred. However there are some cases where the detection needs to be turned
off, or biased towards film.
• Off – Turns off film detection in the deinterlacer. All video sources are treated as original video
• Film Bias – The Film Bias mode may improve film mode detection in some cases.
For example, it may improve the detection of PAL/SECAM film sources.
• Auto - Source adaptive deinterlacing is on. This is the preferred setting as it sets the
deinterlacer to optimally process a variety of signal types and quality.
HDCP Mode
There are two HDCP modes:
• Off: HdCp is disabled at the iscan Vp30’s HdMi input. some sources turn off HdCp in
this case and the iScan VP30 drives a non-HDCP DVI display or an analog display.
• On: The iscan Vp30 continuously looks for a HdCp source on its HdMi input.
Auto Input Priority Selection
The auto input priority selection function assigns different priorities to the video input’s automatic
active video selection mode (AUTO in Input Select menu). First select the video input, then change
the priority of that input.
1 - Press the Down button. The first video input VIDEO 1 is shown.
2 - Press the Enter button to view the current priority of the selected input.
3 - Press the Up or Down button to change the priority of the selected input.
4 - Press the Exit button again to complete the priority assignment.
5 - Repeat Steps 1 through 4 to select the next video input and adjust the priority setting.
Audio Input
The audio input function assigns an audio input to the currently selected video input. four digital
audio inputs and a single analog audio input are available.
To assign the audio input to another video input, push the Down button. The front panel display
(FPD) shows the current setting. For more info about how to assign an audio input to a video input,
refer to Audio Input Operation.
AV Lip Sync
The iscan Vp30 automatically delays the input audio to match the video processing delay. You can
choose to increase or decrease the audio delay by changing this setting. push the Up or Down