Abt VP30 - Manual (Page 13)

9
output status
resolution
frame rate
line rate
Aspect Ratio (Display/Screen)
This screen can be helpful during troubleshooting.
Power Supply Input
The iScan VP30 comes with a 6V@5A AC-to-DC converter power supply, which accepts 100-240 VAC
at 50/60Hz.
To attach power to the unit:
. attach the removable power cord to the external power supply.
2. Plug the removable power cord into a wall outlet or power conditioner, if applicable.
3. plug the small connector attached to the cable that comes out of the power supply into the
‘DC In’ port on the back of the iScan VP30. The iScan VP30 should power on and display
‘DVDO iScan VP30 Powered by ABT’ on the FPD for a couple of seconds.
IMPORTANT: Use only the power supply that came with your iScan VP30, or a replacement
procured directly from ABT.