Beijer Electronics SCOM Protocol EN - Manual (Page 72)

Command Reference
72 Beijer Electronics, MAEN975
6.36 LAU_CONFIG_GETECDISMODE (0x0114)
ECDIS Mode
This command returns the configuration for the startup ECDIS mode. ECDIS
mode is used to configure the display with a set of default configurations for color
and brightness. All Beijer Electronics Nautic Monitors supporting ECDIS mode
have a dedicated button on the front panel, to manually enable or disable ECDIS
mode, but can also be configured to automatically enter ECDIS mode at power on.
Supported since Firmware Version
MT230 Nautic Monitor: 1.0
Command Stream
Response Message (Acknowledge)
Response Message (Negative Acknowledge)
Under normal operation conditions, a device never sends a negative acknowledge in
response to this command.
Maximum Lr for this Command
9
Example
Get the power on ECDIS mode configuration of the monitor at address 0.7 (group
0, address 7):
According to the data returned by the monitor at address 10.7 (group 0, address 7),
the power on ECDIS mode is enabled:
0 1 2 3 4 5 6 7...8 9
0x07 ADR 0x4C 0x41 0x55 0x02 ICHKH 0x01 0x14 ICHKD
0 1 2 3 4 5 6 7 8
0x06 ADR 0x4C 0x41 0x55 0x01 ICHKH Ret ICHKD
Ret
Value: 0x00: Power on ECDIS mode disabled
0x01: Power on ECDIS mode enabled
Type: Byte
Length: 1
Description: Power on ECDIS mode
0 1 2 3 4 5 6 7...8 9
0x07 0x07 0x4C 0x41 0x55 0x02 0x0D 0x01 0x14 0xEA
0 1 2 3 4 5 6 7 8
0x06 0x07 0x4C 0x41 0x55 0x01 0x0F 0x00 0xFF