Beijer Electronics SCOM Protocol EN - Manual (Page 75)

Command Reference
Beijer Electronics, MAEN975 75
6.39 LAU_CONFIG_GETECDISCOLOURTEMP
(0x0117)
ECDIS Default Color Temperature
If ECDIS mode is enabled, the backlight and video controller are configured with
predefined settings. This command returns the predefined color temperature used to
setup the video controller in ECDIS mode.
Supported since Firmware Version
MT230 Nautic Monitor: 1.0
Command Stream
Response Message (Acknowledge)
Maximum Lr for this Command
9
Example
Read the predefined colour temperature of the monitor at address 0.7 (group 0, ad-
dress 7), which is used in ECDIS mode:
According to the data returned by the monitor at address 0.7 (group 0, address 7),
the predefined colour temperature in ECDIS mode is “USER” (0x04):
0 1 2 3 4 5 6 7...8 9
0x07 ADR 0x4C 0x41 0x55 0x02 ICHKH 0x01 0x17 ICHKD
0 1 2 3 4 5 6 7 8
0x06 ADR 0x4C 0x41 0x55 0x01 ICHKH Ret ICHKD
Ret
Value: 0: 9300K
1: 7300K
3: 5000K
4: USER
Type: Byte
Length: 1
Description: Color temperature used in ECDIS mode
0 1 2 3 4 5 6 7...8 9
0x07 0x07 0x4C 0x41 0x55 0x02 0x0D 0x01 0x17 0xFB
0 1 2 3 4 5 6 7 8
0x06 0x07 0x4C 0x41 0x55 0x01 0x0F 0x04 0xFB