Beijer Electronics SCOM Protocol EN - Manual (Page 82)

Command Reference
82 Beijer Electronics, MAEN975
6.46 LAU_CONFIG_GETADDRESSLIST
(0x011E)
Remote Control Address List
If a Beijer Electronics Nautic Monitor is configured as remote controller, this com-
mand returns the addresses of monitors which should be controlled remotely. The
address list is returned as a bit field with 16 bits, enabling a total number of 16 mon-
itors to be controlled remotely. A Beijer Electronics Nautic Monitor always addresses
the monitors within its own group, starting with the lowest address. The group bits
are added automatically to the address field, before the command is sent.
Supported since Firmware Version
MT230 Nautic Monitor: 1.0
Command Stream
Response Message (Acknowledge)
Response Message (Negative Acknowledge)
Under normal operation conditions, a device never sends a negative acknowledge in
response to this command.
Maximum Lr for this Command
10
0 1 2 3 4 5 6 7...8 9
0x07 ADR 0x4C 0x41 0x55 0x02 ICHKH 0x01 0x1E ICHKD
0 1 2 3 4 5 6 7...8 8
0x06 ADR 0x4C 0x41 0x55 0x02 ICHKH Ret ICHKD
Ret
Value: 0...65535
Type: Unsigned short
Length: 2
Description: Bit field containing the address list, where the first byte is
LSB. Each bit corresponds to one monitor address. Bit 0
specifies a monitor at address 0 and bit 15 a monitor at
address 15. If a bit is set (1), the corresponding monitor will
be controlled remotely.