Beijer Electronics AN-BEI-H2-038 - Manual (Page 11)

APPLICATION NOTE AN‐BEI‐H2‐038 Date: 15/02/12
AN‐BEI‐H2‐038 Modbus RTU Control and Register Mapping 11
Group 8 : Application Specific Parameters ‐ Level 3
Parameter Register
Number Description Range Scaling Type
P8‐01 801 Stir Function Interval Time 0 to 6000 U16
P8‐02 802 Stir Activity Time 1 to 6000 U16
P8‐03 803 Pump Clean Function Configuration
0 : Disabled
1 : Active on Start Only
2 : Active on Torque Detection Only
3 : Active on Start & Over Torque Detection U16
P8‐04 804 Clean Time interval 0 to 600 U16
P8‐05 805 Pump Clean Function Ramp Time 0 to 60000 1 = 0.1s U16
P8‐06 806 Load Profile Monitor Function Enable
0 : Disabled
1 : Low Load Detection
2 : High Load Detection
3 : Low & High Load Detection U16
P8‐07 807 Load Profile Monitoring Bandwidth 10 to 1000 10 = 1.0A U16
P8‐08 808 Load Profile Monitoring Trip Delay 0 to 60 U16
P8‐09 809 Fire Mode Logic
0 : Open Activation (Normally Closed)
1 : Closed Activation (Normally Open) U16
P8‐10 810 Fire Mode Speed ‐7200 to 7200 (Limited by P1‐01) 3000 = 50.0Hz S16
P8‐11 811 Bypass Mode On Fault
0 : Disabled
1 : Enabled U16
P8‐12 812 Bypass Mode On Fire
0 : Disabled
1 : Enabled U16
P8‐13 813 Bypass Contactor Changeover Time 0 to 300 1 = 0.1 s U16
P8‐14 814 Pump Staging Function Select
0 : Disabled
1 : Single Drive, Fixed Speed Assist
2 : Multi Drive Optiflow Control U16
P8‐15 815 Pump Staging Additional Pumps 0 to 4 U16
P8‐16 816 Pump Staging Duty Switchover Time 0 to 1000 U16
P8‐17 817 Pump Staging DOL Switch in speed 0 to 7200 (Limited by P1‐01) 3000 = 50.0Hz U16
P8‐18 818 Pump Staging DOL Switch out speed 0 to 7200 (Limited by P1‐01) 3000 = 50.0Hz U16
P8‐19 819 Pump Staging System Settle Time 10 to 600 U16
P8‐20 820 Pump Staging Master Clock Reset
0 : No Function
1 : Reset Timer U16