Hawk Industries Hawkjaw Sr. Manual 100K-2GSR Serial Numbers 121 to 140 - Manual (Page 21)

1. Stab the drill stand.
2. Center the Suspension Ring (SR)
on the Lateral tilt screw (LTS).
3. Push and hold down Winch On
(WOn) to move the HawkJaw onto
the drill pipe connection.
4. Use Raise (R) and Lower (L) to
center the Top wrench dies (TD) and
the Middle wrench dies (MD)
between the shoulder (S).
5. Keep the Middle wrench dies (MD)
away from the Hard banding (HB).
6. Keep the Top wrench dies (TD) and
Middle wrench dies (MD) away
from the shoulder (S).
Continued on next page...
Position for Make Up Position for Make Up
R L
MD HB
S TD
WOn
SR LTS
20 Operation