Hawk Industries Hawkjaw Sr. Manual 100K-2GSR Serial Numbers 121 to 140 - Manual (Page 30)

1. Rotate the Selector Switch (SS)
clockwise to the break position.
2. Push in the Grip Hold (GH)
button.
3. Push and hold in the wrench Grip
(G).
4. Push and hold down Torque (T).
5. When break out occurs, release
Torque (T). Immediately release the
wrench Grip (G). See note below.
6. Press and hold down Spin (S) until
the stand pops out of the connection.
Release Spin (S). If the stand will
not spin, release Spin (S).
Repeat Steps 4-6.
7. Pull out the Grip Hold (GH) button.
8. You are now able to remove the
Hawkjaw from the pipe.
Break Out Break Out
SS G GH
T S
TN
Shown set for 35,000 ft. lbs.
Operation 29