Goulds Pumps XHD - IOM User Manual
Installation, operation, and maintenance manual
Advertising
Table of contents
Document Outline
- Introduction and Safety
- Transportation and Storage
- Product Description
- Installation
- Preinstallation
- Baseplate-mounting procedures
- Install pump, driver, and v-belt drive
- Install the pump, driver, and coupling
- Pump-to-driver alignment
- Alignment checks
- Permitted indicator values for alignment checks
- Alignment measurement guidelines
- Attach the dial indicators for alignment
- Pump-to-driver alignment instructions
- Perform angular alignment for a vertical correction
- Perform angular alignment for a horizontal correction
- Perform parallel alignment for a vertical correction
- Perform parallel alignment for a horizontal correction
- Perform complete alignment for a vertical correction
- Perform complete alignment for a horizontal correction
- Grout the baseplate
- Piping checklists
- Commissioning, Startup, Operation, and Shutdown
- Preparation for startup
- Remove the V-belt drive guard
- Remove the coupling guard
- Check the rotation
- Impeller-clearance check
- Impeller-clearance setting
- Install the V-belt drive guard
- V-Belt drive operation
- Couple the pump and driver
- Bearing lubrication
- Shaft-sealing options
- Pump priming
- Start the pump
- Activate the i-ALERT Condition Monitor
- i-ALERT™ Condition Monitor routine operation
- Pump operation precautions
- Shut down the pump
- Deactivate the i-ALERT™ Condition Monitor
- Reset the i-ALERT™ Condition Monitor
- Make the final alignment of the pump and driver
- Maintenance
- Maintenance schedule
- Disassembly
- Disassembly precautions
- Tools required
- Typical disassembly
- Complete wet end disconnection - XHD only
- Wet end disassembly instructions
- Remove the joint gaskets and flanges
- Remove the suction half casing
- Remove the remaining suction half components
- Remove suction side liner - XHD Value Option
- Remove the suction side liner and adjustable seal ring - XHD
- Remove the adjustable seal ring - XHD
- Impeller removal
- Stuffing box removal
- Remove the split stuffing box XHD
- Remove the casing volute liner
- Remove the expeller (optional feature)
- Remove the seal cover and gland half casing assembly
- Optional disassembly of gland half casing, volute liner, and seal cover
- Locate and lift the volute liner for optional discharge locations (field replacement)
- Remove the shaft sleeve
- Remove the power end - quick disconnect option for XHD
- Remove the power end- XHD and XHD Value Option
- Disassemble the power end - XHD, oil lubrication
- Disassembly of other power end configurations
- Preassembly inspections
- Reassembly
- Assemble the power end- XHD, oil lubrication
- Assemble the power end to the pedestal
- Assembly of other power end configurations
- Wet end assembly instructions
- Complete wet end connection - XHD
- Wet end assembly instructions
- Install the knock-off ring
- Install the shaft sleeve
- Install the gland half casing and seal cover
- Stuffing box assembly and installation
- Install the seal cover
- Assemble the split stuffing box - XHD
- Install the expeller (optional feature)
- Install the casing volute liner
- Install the impeller
- Suction side assembly
- Install suction side liner into suction half casing - XHD Value Option
- Install adjustable seal ring and suction side liner into suction half casing - XHD
- Install suction half casing with other suction half components attached
- Install packing, lantern ring, and gland
- Install the flanges and joint gaskets
- Assembly references
- Troubleshooting
- Parts Listings and Cross-Sectionals
- Certification: CE or CE ATEX
- Other Relevant Documentation or Manuals
- Local ITT Contacts