Muxlab Multimedia 16 x 16 Matrix Switch - Manual (Page 15)

© MuxLab Inc. Multimedia 16x16 Matrix Switch Installation Guide
Page 15
3.5. Installation Procedure
In order to install the product, please follow the steps below:
1. Place the Multimedia 16x16 Matrix Switch in its final location (see Section 3.4
Physical Installation).
2. If another power supply unit is required for redundancy, install it (see Section 3.7
Power Supply Unit Installation).
3. Install the input and output cards modules. Input card modules fit into the four
slots on the left side of the back panel, and output card modules fit into the four
slots on the center-right side of the back panel (see Section 3.6 Card Module
Installation).
4. Connect the source(s) to the Matrix Switch via ports on the input card modules
located on the back panel. Ensure that power is turned OFF at the source(s).
5. Connect the display(s) to the Matrix Switch via ports on the output card modules
located on the back panel. Ensure that the display(s) are turned OFF. For
HDBaseT outputs, MuxLab Receivers must be installed at the displays (see
MuxLab Receiver Installation Guide for more information).
6. Power up the equipment.
The Matrix Switch is now ready to use. See Section 3.9 Manual Control for
instructions on using the Matrix Switch.