Muxlab Multimedia 16 x 16 Matrix Switch - Manual (Page 32)

© MuxLab Inc. Multimedia 16x16 Matrix Switch Installation Guide
Page 32
3.12. Ethernet Web Interface
MuxLab offers users an Ethernet Web interface that provides the same functionality as
manual control, with speeds of 10 Mbps or 100 Mbps.
To use the Ethernet Web interface, the Multimedia 16x16 Matrix Switch must first be
physically connected to an Ethernet network. To do this, locate the RJ45 Ethernet jack on
the back panel of the Matrix Switch, then connect it to an Ethernet network using a
straight UTP cable (maximum length: 333 feet [100 meters]). There are two LEDs at the
bottom of the RJ45 Ethernet jack: A green LED will go on if a link is detected, and a
yellow LED will blink if Ethernet activity is detected.
Once the Matrix Switch has been physically connected to an Ethernet network, go to
http://AAA.BBB.CCC.DDD , where AAA.BBB.CCC.DDD is the device IP address.
(NOTE: The device IP address can be obtained by pressing the Info button on the front
panel.)
The Login screen is the first screen to appear (Figure 18).
Figure 18: Ethernet Web Interface Login Screen
The default password for administrators is admin. The default password for regular
users is user.
NOTE: Users who have previously logged in and chosen a password, but have
subsequently forgotten it, may connect to the device using the RS232 or USB and
reset their password using a terminal emulator.
Three items are presented to the user at the top right of every Ethernet Web interface
screen:
• Logout option
• Language option
• Product status