Page 51 – Muxlab Multimedia 16 x 16 Matrix Switch User Manual
Page 51
© MuxLab Inc.
Multimedia 16x16 Matrix Switch Installation Guide
Page 51
Network –m
<mask address>
Description: Set a specific mask address (note that DHCP must be disabled to perform this action)
Arguments:
<mask address>: #.#.#.#
Example:
Set the mask address to 255.255.255.0
Network –m 255.255.255.0
Response:
IP: 192.25.80.13
MASK: 255.255.255.0
GATEWAY: 10.0.0.1
DHCP: OFF
(or an error message if the command failed)
Network –g
<gateway address>
Description: Set a specific gateway address (note that DHCP must be disabled to perform this action)
Arguments:
<gateway address>: #.#.#.#
Example:
Set the gateway address to 10.101.1.5
Network –g 10.101.1.5
Response:
IP: 192.25.80.13
MASK: 255.255.255.0
GATEWAY: 10.101.1.5
DHCP: OFF
(or an error message if the command failed)
Network –dhcp
<dhcp state>
Description: Enable/disable
DHCP
feature
Arguments:
<dhcp state>: on or off
Example:
Enable the DHCP feature
Network –dhcp on
Response:
IP: 10.0.1.101
MASK: 255.255.0.0
GATEWAY: 10.101.1.5
DHCP: ON
(or an error message if the command failed)
8. Password
password -panel
<password # >
Description: Set the front panel password
Arguments:
<password # >: 4 digits
Example:
Set the front panel password to 1234
password -panel 1234
Response:
password panel set successfully
(or an error message if the command failed)