Muxlab Multimedia 16 x 16 Matrix Switch - Manual (Page 17)

© MuxLab Inc. Multimedia 16x16 Matrix Switch Installation Guide
Page 17
3.7. Power Supply Unit Installation
To install a power supply unit in the Multimedia 16x16 Matrix Switch, please follow
the steps below:
1. Holding the power supply unit with both hands (one on the chrome handle and the
other on the top clip), align the power supply unit with the sliding rail found in the
given power supply slot at the back of the Matrix Switch.
2. Gently slide the power supply unit into the slot. A hard stop should be felt when
the power supply unit back surface is flush with the outside surface of the back
panel.
3. Tighten both screws at the power supply unit back surface.
4. Plug the power cord into the power supply unit socket and secure it with the clip.
NOTE: Power supply units are hot-swappable,
meaning that they can be replaced when power on
the Matrix Switch is ON. When hot-swapping a
power supply unit, follow all standard safety
precautions for working with live circuitry.
Figure 10: Power Supply Unit Installation