Muxlab Multimedia 16 x 16 Matrix Switch - Manual (Page 16)

© MuxLab Inc. Multimedia 16x16 Matrix Switch Installation Guide
Page 16
3.6. Card Module Installation
To install a card module in the Multimedia 16x16 Matrix Switch, please follow the
steps below:
1. Align the card module with the plastic rail found in the given slot at the back of the
Matrix Switch.
2. Gently slide the card module into the slot. A hard stop should be felt when the
connector interface of the card module is flush with the outside surface of the back
panel.
3. Tighten both thumbscrews to secure the card module to the back panel of the
Matrix Switch.
NOTE: Card modules are hot-swappable, meaning that they can be replaced when
power on the Matrix Switch is ON. When hot-swapping a card module, follow all
standard safety precautions for working with live circuitry.
Figure 9: Card Module Installation