Anritsu MP1763C - Manual (Page 23)

1-7
1.2 Specifications
Option-01 Name Internal synthesizer
Frequency range 0.05 to 12.5 GHz
Output level 0.5 to 2.3 Vp-p
Resolution 1 kHz/1 MHz (switchable)
Frequency accuracy 1ppm (
∗
When synchronized with external signal, accuracy is
determined by external signal.)
Reference signal 10 MHz (internal/external switchable)
Signal purity SSB phase noise (10 kHz offset, bandwidth 1 Hz)
10.0
0.05 Freq. < 2.0 GHz –90 dBc
2.0 Freq. < 4.0 GHz –85 dBc
4.0 Freq. < 8.0 GHz –80 dBc
8.0 Freq. <10.0 GHz –75 dBc
Freq. 12.5 GHz –70 dBc
Spurious radiation At Internal synthesizer output terminal
Nonharmonic –60 dBc or less (off carrier 10 kHz or more)
Power supply –40 dBc or less
Load impedance 50
Ω
Connector SMA
Option-03 Name 1/4 SPEED OUTPUT
Number of output 4 data outputs, 1 clock output
Output bit rate 1/4 of fundamental frequency
Amplitude
0.5 to 2.0 Vp-p/Step 2 mV
Setting error:
±15% or ±100 mV, whichever is larger
Offset voltage
–1.5 to +1.5 V (V OH )/Step 1 mV
Setting error: ±15 % or ±15 % of Amplitude, and ±100 mV,
whichever is larger
Rise/fall time 150 ps or less (20-80 %)
Pattern jitter
15 % or less
Skew
Output impedance
The 1/4 data cross point is within
±100 ps relative to the falling edge
of the 1/4 clock.
Connector SMA
50
Ω
Waveform distortion
100 ps or less (p-p)
Data polarity Same as 1/1 DATA
Termination 50 Ω/GND, 50 Ω/–2 V
* When OPTION 03 is installed, there is no 1/8 output.