Anritsu MP1763C - Manual (Page 71)

7-1
SECTION 7
MAINTENANCE
7.1 Daily Maintenance
• Wipe external dirt with a cloth soaked in a diluted neutral detergent.
• Remove dust or specks by using a vacuum cleaner.
• Periodically clean the FDD head by using a 3.5-inch head-cleaning disk.
• If any loosened screws for attached parts are found, secure by using the specified tool.
7.2 Storage Precautions
(1) Store the unit after removing any dirt or dust.
(2) Do not store the unit in a place with a temperature of over +60 ˚C, under –20 ˚C, or with humidity of over 85 %.
(3) Do not store the unit in a place where it may be exposed to direct sunlight or dust.
(4) Do not store the unit in a place where it may be exposed to dew and active gas.
(5) Do not store the unit in a place where it may be oxidized or exposed to strong vibrations.
• Recommended storage conditions
When the unit is stored for a long period, we recommend observing the following conditions in addition to those discussed
above:
1. Temperature : 5 to 30 ˚C
2. Humidity : 40 to 75 %
3. Place where the temperature and humidity are stable throughout the day.
7.3 Transportation
When transporting the unit, use the original packing material, if available. If not available, follow the packing procedures
shown below. Wear clean gloves and handle equipment gently, so as not to scratch or dent them.
(1) Wipe off dirt or dust on the unit surface with a dry cloth.
(2) Check for loosened or missing screws.
(3) Protect structural projections or any parts that can be easily damaged and cover the equipment with a polyethylene
sheet. Cover with moisture-proof material.
(4) Put the covered equipment into a cardboard box and close with adhesive tape. Place into a wood box, or other, accord-
ing to the distance or method of transportation.
(5) During transportation, keep the unit in the environmental conditions specified in “7.2 Storage Precautions”.