Lenovo ThinkServer RD630 - Manual (Page 144)

Figure 94. Removing the 2.5-inch hot-swap hard disk drive or dummy tray
3. Touch the static-protective package that contains the new hot-swap hard disk drive to any unpainted
surface on the outside of the server. Then, take the new hot-swap hard disk drive out of the package.
Note: Do not touch the circuit board on the hard disk drive.
4. Slide the new hot-swap hard disk drive into the drive bay from the front until it snaps into position
and then completely close the handle.
Figure 95. Installing the 3.5-inch hot-swap hard disk drive
132 ThinkServer User Guide