Updating the server configuration – Lenovo ThinkServer RD630 User Manual
Page 170
Attention: To avoid component damage, connect the power cord(s) last.
Note: In most areas of the world, Lenovo requires the return of the defective CRU. Information about this will
come with the CRU or will come a few days after the CRU arrives.
Updating the server configuration
When you turn on the server for the first time after you install, remove, or replace a device, you might
need to update the server configuration.
Some optional devices have device drivers that you must install. For information about installing device
drivers, use the documentation that comes with each optional device. To obtain the supported device
drivers for your server from the Lenovo Support Web site, go to and follow
the instructions on the Web page to find and download the device drivers you need.
Refer to the following information resources to update the server configuration:
• To update the BIOS configuration, see “Using the Setup Utility program” on page 55.
• To update the RAID configuration, see “Configuring RAID” on page 66.
• To use the ThinkServer EasyStartup program, see “Using the ThinkServer EasyStartup program” on
• To update your system firmware, see “Updating the firmware” on page 69.
158
ThinkServer User Guide