Lenovo ThinkServer RD630 - Manual (Page 161)

6. Press the release tab 1 in the direction as shown and then push the diagnostic module out of the
front of the chassis.
Figure 113. Removing the diagnostic module for server models with 3.5-inch hard disk drives
7. Touch the static-protective package that contains the new diagnostic module to any unpainted surface
on the outside of the server. Then, take the new diagnostic module out of the package.
8. Slide the new diagnostic module into the chassis from the front until it snaps into position.
Figure 114. Installing the diagnostic module for server models with 3.5-inch hard disk drives
9. Connect the diagnostic module cable to the rear of the new diagnostic module.
Chapter 6 . Installing, removing, or replacing hardware 149