Keyboard, mouse, or usb device problems – Lenovo ThinkServer TS140 User Manual

Page 103

Advertising

Symptom

Action

2. If you have any diagnostic programs, run the

diagnostic programs to test the memory modules.

3. Reinstall the memory modules.

4. Replace the suspect memory modules.

5. (Trained service technician only) Replace the system

board.

Keyboard, mouse, or USB device problems

Follow the suggested actions for the corresponding symptom in the order in which they are listed until the
problem is solved. If none of these actions solve the problem, see “Troubleshooting procedure” on page 87
for the subsequent steps you should check after using the information in this topic.

Symptom

Action

All or some keys on the keyboard do not work.

1. Make sure that:

• The USB keyboard cable is securely connected

to a USB connector on the server. If the USB
keyboard is connected to a USB hub, disconnect
the keyboard from the hub and connect it directly
to the server.

• No keys are stuck.

• The USB controller is enabled in the Setup Utility

program. See “Using the Setup Utility program”
on page 21.

2. Restart the server.

3. Replace the keyboard.

The mouse or pointing device does not work.

1. Make sure that:

• The mouse or pointing device cable is securely

connected to the server. If the USB mouse or
pointing device is connected to a USB hub,
disconnect the mouse or pointing device from the
hub and connect it directly to the server.

• The mouse or pointing device is clean and no dust

accumulates.

• The device drivers are installed correctly.

• The USB controller is enabled in the Setup Utility

program. See “Using the Setup Utility program”
on page 21.

2. Restart the server.

3. Replace the mouse or pointing device.

A USB device does not work.

1. Make sure that:

• The USB cable is securely connected to the server.

If the USB device is connected to a USB hub,
disconnect the device from the hub and connect
it directly to the server.

• The device drivers are installed correctly.