Lenovo ThinkServer TS140 - Manual (Page 65)

8. Slide the new hard disk drive into the hard disk drive cage until it snaps into position.
Figure 23. Installing the secondary hard disk drive
9. Connect one end of the signal cable to the hard disk drive and the other end to an available SATA
connector on the system board. See “Locating parts on the system board” on page 16. Then, locate an
available five-wire power connector and connect it to the hard disk drive.
Figure 24. Connecting a SATA hard disk drive
Installing or removing the tertiary hard disk drive
This topic provides instructions on how to install or remove the tertiary hard disk drive.
Note: For a 2.5-inch hard disk drive or solid-state drive, install the drive into a 3.5-inch to 2.5-inch drive
adapter first. See “Installing the 2.5-inch solid-state drive or hard disk drive” on page 47.
Installing the tertiary hard disk drive
Attention: Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii and “Guidelines” on page 37.
You can install a tertiary 3.5-inch hard disk drive into the secondary optical drive bay of your server.
Chapter 6 . Installing, removing, or replacing hardware 53