Lenovo ThinkServer TS140 User Manual
Page 63
9. Connect one end of the signal cable to the hard disk drive and the other end to an available SATA
connector on the system board. See “Locating parts on the system board” on page 16. Then, locate an
available five-wire power connector and connect it to the hard disk drive.
Figure 20. Connecting a SATA hard disk drive
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to “Completing the parts replacement” on page 84.
Installing or replacing the secondary hard disk drive
Attention: Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii and “Guidelines” on page 37.
This topic provides instructions on how to install or replace the secondary hard disk drive.
Note: For a 2.5-inch hard disk drive or solid-state drive, install the drive into a 3.5-inch to 2.5-inch drive
adapter first. See “Installing the 2.5-inch solid-state drive or hard disk drive” on page 47.
To install or replace the secondary hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 39.
3. Locate the secondary hard disk drive. See “Locating parts on the system board” on page 16 and
4. If you are replacing the secondary hard disk drive, disconnect the signal cable and the power cable
from the hard disk drive.
.
Installing, removing, or replacing hardware
51