Lenovo ThinkServer TS140 - Manual (Page 74)

What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to “Completing the parts replacement” on page 84.
Removing the slim optical drive and the fourth hard disk drive
Attention: Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii and “Guidelines” on page 37.
This topic provides instructions on how to remove the slim optical drive and the fourth hard disk drive.
To remove the slim optical drive and the fourth hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 39.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on page 40.
4. Disconnect the signal cables and the power cables from the slim optical drive and the fourth hard
disk drive.
5. Disconnect the cable of the fan for the fourth hard disk drive from the hard disk drive fan connector on
the system board. See “Locating parts on the system board” on page 16.
Note: If your server has a tertiary hard disk drive installed, disconnect the cable of the fan for the fourth
hard disk drive from the fan power converter cable.
6. Press the release button 1 and slide the cage with the slim optical drive and the fourth hard disk drive
out of the front of the server.
Figure 41. Removing the cage with the slim optical drive and the fourth hard disk drive
62 ThinkServer TS140 User Guide