Lenovo ThinkServer TS140 - Manual (Page 66)

This topic provides instructions on how to install the tertiary hard disk drive.
To install the tertiary hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 39.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on page 40.
4. Install the hard disk drive into the 5.25-inch to 3.5-inch drive conversion bracket. Then, install the four
screws to secure the hard disk drive in the bracket.
Note: You can obtain a 5.25-inch to 3.5-inch drive conversion bracket from a local computer retailer
or by contacting the Customer Support Center.
Figure 25. Installing the hard disk drive into the drive conversion bracket
5. Install the retainer on the side of the bracket.
Figure 26. Installing the retainer on the side of the bracket
6. If there is a metal static shield installed in the secondary optical drive bay, remove the metal static shield.
54 ThinkServer TS140 User Guide