Actron 9640 - Manual (Page 115)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 7 – 3
Chrysler Diagnostics
7
Use the UP/DOWN arrow keys to scroll
through the codes. Note the codes and
press FUNC to return to the Chrysler
Functions list.
Use the UP/DOWN arrow keys to scroll
through the codes. Write down the
codes for reference or print them later.
The DTCs are categorized by ENG (engine) or TRANS (transmission). The
Chrysler MIL code (3-digit) and SAE code (5-digit) follow on the first line.
There may be times where only one or both display. Dashes display if the DTC
type does not exist.
Note the codes and press BACK to return to the Chrysler Functions list.
ERASE CODES
The Erase Codes function deletes the DTCs from the vehicle’s computer mem-
ory. Perform this function only after the systems have been checked completely
and DTCs have been documented. This function should be performed KOEO.
Do not START engine.
After servicing the vehicle, erase the stored DTCs, perform a road test, and then
verify no new codes have been stored. If DTCs return, the problem has not been
corrected or other faults are present.
Select Erase Codes and press the
ENTER key.
Follow the instructions and press
ENTER.
ENG: 14/P0107
MAP Voltage Too
Low
~
ENG: 31/P0443
EVAP Purge Solenoid
Circuit
~
ENG: 31/P0443
EVAP Purge Solenoid
Circuit
~
TRANS: 18/P1792
Battery
]
Disconnected [
(In Last 50 Cycles) ~
ENG: 7/----
Boost Limit
Exceeded
~
ENG: ---/P0010
Camshaft Position
]
Actuator A - Bank 1[
Circuit Malfunction ~
Chrysler Functions
1)Read Codes
2)Read Temp Codes [
` 3)Erase Codes ~
Turn Ign Key On.
Engine Must Be Off
To Erase Codes.
Press ENTER To Cont~