Erase codes, Eec-iv erase codes – Actron 9640 User Manual
Page 87
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 6 – 7
Ford Historic Self-Test Routines
6
Erase Codes
The vehicle service manual may recommend erasing Continuous Memory
Codes from vehicle’s memory, and then driving vehicle to duplicate the
malfunction before beginning a diagnostic test. If KOEO codes were read using
Fast Codes, the memory codes have already been erased.
Only Continuous Memory Codes can be erased from the vehicle without
repairing the fault. To remove KOEO and KOER Codes, the fault must be
repaired since they only exist when a fault exists.
EEC-IV Erase Codes
Select Erase Codes from the Ford
Function List and press
ENTER.
Press
ENTER after each message.
Follow all instructions on the display.
1) Turn Ign Key Off.
2) Transmission In Park Or Neutral.
3) Wait 10 Seconds.
4) Turn Ign Key On.
Press
ENTER to begin erasing the
codes. The procedure takes less 1
minute to run.
Press
FUNC to return to the Ford
Function List.
Ford Function List ?
3)Review Codes
]
` 4)Erase Codes
[
5)Wiggle test
~
Only Memory Codes
Are Erasable!
Press ENTER to Cont~
To Erase KOEO And
KOER Codes, You Must
Fix Cause of Code.
Press ENTER to Cont~
Erasing Codes
Procedure Runs Less
Than 1 Minute.
Time Remaining=0:53 ~