Review data – Actron 9640 User Manual
Page 124
Chrysler Diagnostics
7 – 12 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
7
✓
Set Sync Mode is available on 3.9L, 5.2L and 5.9L engines only.
When returning to the Chrysler Functions list, timing will remain fixed. This
allows the mechanic to use the Sensor Test function and read sensor data. To
restore timing, the Abolish Request mode must be selected from the Select
Request Mode menu.
Depending on the Request Mode sent to the PCM, the tool will display the
following messages:
• Basic Timing Has Been Abolished.
• Basic Timing Has Been Initiated. Spark Is Being Fired At Predetermined Set
Point Without Spark Scatter.
• Basic Timing or Set Sync Is Rejected Due To Open Throttle.
• Basic Timing Is Rejected Due To Automatic Transmission In DRIVE.
• Set Sync Has Been Initiated.
REVIEW DATA
The Review Data function allows you to review data stored in the scan tool.
Select Review Data and press
ENTER.
The types of stored data are listed.
Select an option and press
ENTER.
Codes, Temp Codes Freeze Frame
and Controller Info display the
information stored when those functions
were ran.
The Playback function is used to play back a recording. This function is very
similar to View Data. The only difference is that View Data is a real time viewing
of PIDs, while Playback is a viewing of previously recorded PIDs.
To play back your vehicle’s recorded PIDs, select Playback from the Review
Data list. Press the
ENTER key to continue.
✓
On 1999 and newer vehicles, a screen may ask you to select Engine Data
or Transmission Data.
The scan tool displays a NO RECORDING PRESENT message if a recording
does not exist. Otherwise, press
ENTER to play back the recording. The scan
tool plays back the Entire Data List or the Custom Data List, depending on
how the data was recorded.
The Playback is composed of three
lines of data and one line for the frame
number and timestamp (in seconds).
Negative frames and timestamps
indicate data recorded before the
trigger event. Positive frames and
timestamps indicate data recorded after
the trigger event.
Chrysler Functions ?
12)Set Basic Time ]
` 13)Review Data
[
14)Print Data
~
Review Data
?
1)Codes
` 2)Temp Codes
[
3)Playback Data
~
COOLANT(V)
5.00
COOLANT(
O
F)
114
ENGINE(RPM)
0[
FRAME: -5 TM: -6.6
~