Lenovo ThinkServer TD350 - Manual (Page 160)

8. Loosen the two screws that secure the AnyRAID adapter or the pass-through board. Then, grasp the
AnyRAID adapter or the pass-through board by its edges and carefully pull it out of the AnyRAID-adapter
slots on the backplane.
Notes:
• The AnyRAID adapter or the pass-through board fits tightly into the AnyRAID-adapter slots. If
necessary, alternate moving each side of the AnyRAID adapter or the pass-through board a small and
equal amount until it is removed from the connectors.
• The two screws are integrated parts of the AnyRAID adapter or the pass-through board. Do not try to
remove the two screws from the AnyRAID adapter or the pass-through board.
Figure 111. Removing the AnyRAID adapter or the pass-through board
9. Under the AnyRAID adapter or the pass-through board, there is an AnyRAID-adapter tray used to help
secure the AnyRAID adapter or the pass-through board in place. If necessary, remove and reinstall the
tray by doing the following:
Note: Depending on the model, the AnyRAID-adapter tray that comes with your server might look slightly
different with the following illustrations. However, the removal and installation procedures are the same.
146 ThinkServer TD350 User Guide and Hardware Maintenance Manual