Configuring the tpm function, Exiting the setup utility program, Updating or recovering the bios – Lenovo ThinkServer TD350 User Manual
Page 70
3. Press F10 to save settings and exit the Setup Utility program. The server will follow the startup device
sequence you have set each time you turn on the server.
Configuring the TPM function
The TPM works as a hardware security solution to help you to encrypt data and protect the server. The TPM
function is only available when there is a TPM installed in your server. See “Installing the TPM” on page 103.
You can purchase a TPM from the Lenovo Web site at:
After installing a TPM, check if the TPM function is enabled in the Setup Utility program.
To enable the TPM function in the Setup Utility program, do the following:
1. Start the Setup Utility program. See “Starting the Setup Utility program” on page 51.
2. On the System Security menu, select TPM Settings ➙ TPM Support. Ensure that TPM Support is
set to Enabled.
3. When TPM Support is set to Enabled, the TPM State item is displayed. Set TPM State to Enabled.
4. Press F10 to save settings and exit the Setup Utility program. The server will restart to enable the
TPM function.
Setting an Ethernet connector for system management
There are three RJ-45 Ethernet connectors on the rear of the server. The Ethernet connector 0 is for system
management by default. However, you also can set the Ethernet connector 1 for system management use.
To locate the three Ethernet connectors, see “Rear view of the server” on page 22.
To set the Ethernet connector for system management, do the following:
1. Start the Setup Utility program. See “Starting the Setup Utility program” on page 51.
2. On the TSM Settings menu, select TSM Network Settings ➙ TSM NIC Selection.
3. Do one of the following:
• To set the Ethernet connector 0 for system management, select Dedicated Port.
• To set the Ethernet connector 1 for system management, select Shared NIC Port.
4. Press F10 to save settings and exit the Setup Utility program.
Exiting the Setup Utility program
After you finish viewing or changing settings, press Esc to return to the Setup Utility program main interface.
If you are on a nested submenu, press Esc repeatedly until you reach the main interface. Then, you can do
one of the following to exit the Setup Utility program:
• If you want to save the new settings and exit the Setup Utility program, press F10 or select Save & Exit ➙
Save Changes and Reset. Otherwise, your changes will not be saved.
• If you do not want to save the new settings, select Save & Exit ➙ Discard Changes and Exit.
• If you want to return to the default settings, press F9 or select Save & Exit ➙ Load Optimized Defaults.
For more information about the Save & Exit menu in the Setup Utility program, see “Save & Exit menu”
on page 53.
Updating or recovering the BIOS
This topic provides instructions on how to update the BIOS and how to recover from a POST and BIOS
update failure.
56
ThinkServer TD350 User Guide and Hardware Maintenance Manual