Lenovo ThinkServer TD350 User Manual
Page 59
The following illustration shows the status of the jumpers on the system board of your server.
Figure 26. System board jumpers
Table 1. System board jumpers
1
Clear password jumper
2
BIOS default settings jumper
3
BIOS recovery jumper
Attention: To set the jumpers, remove the server cover and the cooling shroud to access the system board.
Do not open your server or attempt any repair before reading and understanding “Safety information” on
page iii and “Guidelines” on page 63.
1
Clear password jumper
Use the jumper to erase forgotten passwords, such as an administrator password and a user password.
To clear passwords, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a flat,
clean, and static-protective surface. See the Rack Installation Instructions that comes with the server. If
the server is in tower form factor, lay the server on its side for easier operation.
3. Remove the server cover. See “Removing the server cover” on page 66.
45