Pioneer VSX-859RDS-G - Manual (Page 112)

112
En
Techno Tidbits & Problem-solving
Cause
• Speaker settings are incorrect.
• The rear and/or center levels are
turned down.
• The surround and/or center
speakers are disconnected.
• SIGNAL SELECT is set incorrectly.
• The digital inputs are assigned
incorrectly, or not at all.
• SIGNAL SELECT is set to
“ANALOG”.
• A DVD player not compatible with
DTS is used, or the setting of the
DVD player is incorrect.
• The digital output level has been
turned down on a CD player or
other component equipped with
digital output level adjustment
capability. (The DTS signal has been
altered by the player, and cannot be
read.)
• The speakers are turned OFF.
• Disc being played back has a huge
amount of information on it.
• The search function performed by
the player interferes with the
reading of digital information.
• The remote control batteries have
worn out.
• Too far away or bad angle of
operation.
• There is an obstacle between the
receiver and the remote control.
• Strong light such as fluorescent
light is shining onto the unit's
remote control signal light-receiving
window.
• A cord is connected to the
CONTROL IN terminal on this unit.
• The FL DIMMER button is pushed.
• If you are using an analog source,
the signal is too strong.
• If you are using a digital source,
there is too much information for
the receiver to handle.
• The SIGNAL SELECT is on
ANALOG.
Remedy
• See “SPEAKER SETTING” on p. 36 –
37 to check the speaker settings.
• See “CHANNEL LEVEL” p. 39 – 40 to
check the speaker levels.
• Connect the speakers (see p. 4, 19).
• Set SIGNAL SELECT to “AUTO” or
according to the type of connections
made (see p. 51).
• Set the digital input settings correctly
(see p. 33).
• Make digital connections (see p. 13
&14) and set SIGNAL SELECT to
“AUTO” (see p. 51).
• Refer to the instruction manual
supplied with the DVD player.
• Set the digital volume level of the
player to full, or to the neutral
position.
• Turn the speakers ON.
• Use the STANDARD mode to get
the best results (see p.44).
• This is not a malfunction, but be sure
to turn the volume down to prevent
the output of loud noise from your
speakers.
• Replace the batteries (see p. 10).
• Operate within 7 m, 30° of the remote
sensor on the front panel (see p. 11).
• Remove the obstacle or operate from
another position.
• Avoid exposing the remote sensor on
the front panel to direct light.
• Connect cord to the correct jack.
•Press FL DIMMER on the front panel
repeatedly to return to the default
setting (see p. 56).
• Press the INPUT ATT button (see p.
25, #8 and p.28, #15).
• For 2 /DTS sources put the receiver
in STANDARD mode (see p. 47).
• Set the SIGNAL SELECT to DIGITAL.
Symptom
No sound from surround or
center speakers.
Sound is produced from some
components, but not from
digital components.
No sound is output or a noise is
output when software with DTS
is played back.
The sound is output
intermittently when software
with DTS is played back.
When a search is performed by
a DTS compatible CD player
during playback, noise is output.
Cannot be remote controlled.
The display is dark.
The OVER indicator is
constantly lit.
When playing a DTS format LD
there is noise audible on the
soundtrack.