Pioneer VSX-920-K - Manual (Page 102)

The System Setup and Other Setup menus 11
102
En
Speaker Setting
Use this setting to specify your speaker
configuration (size, number of speakers and
crossover frequency). It is a good idea to make
sure that the settings made in Automatically
conducting optimum sound tuning (Auto
MCACC) on page 39 are correct. Note that this
setting applies to all MCACC presets, and
cannot be set independently.
1 Select ‘Speaker Setting’ from the
Manual SP Setup menu.
2 Choose the set of speakers that you want
to set, then select a speaker size.
Use
/ to select the size (and number) of
each of the following speakers:
1
• Front – Select LARGE if your front
speakers reproduce bass frequencies
effectively, or if you didn’t connect a
subwoofer. Select
SMALL to send the bass
frequencies to the subwoofer.
• Center – Select LARGE if your center
speaker reproduces bass frequencies
effectively, or select
SMALL to send bass
frequencies to the other speakers or
subwoofer. If you didn’t connect a center
speaker, choose
NO (the center channel is
sent to the front speakers).
• FH – Select LARGE if your front height
speakers reproduce bass frequencies
effectively, or select
SMALL to send bass
frequencies to the other speakers or
subwoofer. If you didn’t connect front
height speakers, choose
NO (the front
height channel is sent to the front
speakers).
2
• FW – Select LARGE if your front wide
speakers reproduce bass frequencies
effectively, or select
SMALL to send bass
frequencies to the other speakers or
subwoofer. If you didn’t connect front wide
speakers, choose
NO (the front wide
channel is sent to the front speakers).
3
• Surr – Select LARGE if your surround
speakers reproduce bass frequencies
effectively. Select
SMALL to send bass
frequencies to the other speakers or
subwoofer. If you didn’t connect surround
speakers choose
NO (the sound of the
surround channels is sent to the front
speakers or a subwoofer).
• SB – Select the number of surround back
speakers you have (one, two or none).
4
Select LARGEx2 or LARGEx1 if your
surround back speakers reproduce bass
frequencies effectively. Select
SMALLx2 or
SMALLx1 to send bass frequencies to the
other speakers or subwoofer. If you didn’t
connect surround back speakers choose
NO.
Note
1 If you select SMALL for the front speakers the subwoofer will automatically be fixed to YES. Also, the center, surround,
surround back, front height and front wide speakers can’t be set to LARGE if the front speakers are set to SMALL. In
this case, all bass frequencies are sent to the subwoofer.
2 • You can only adjust the front height speakers when Speaker System is set to Normal(SB/FH).
• If the surround speakers are set to NO, the front height speakers will automatically be set to NO.
3 • You can only adjust the front wide speakers when Speaker System is set to Normal(SB/FW).
• If the surround speakers are set to NO, the front wide speakers will automatically be set to NO.
4 • If you selected ZONE 2 or Front Bi-Amp (in Speaker system setting on page 101) you can’t adjust the surround back
settings.
• If the surround speakers are set to
NO, the surround back speakers will automatically be set to NO.
• If you select one surround back speaker only, make sure that speaker is hooked up to the left surround back
terminal.
VSX-1020_SYXCN.book 102 ページ ２０１０年３月１２日 金曜日 午前９時１０分