Pioneer VSX-920-K - Manual (Page 111)

Additional information 12
111
En
English
Français
Deutsch
Nederlands
Italiano
Español
Noise is output when
scanning a DTS CD. • This is not a malfunction of the receiver. The scan function of your player
alters the digital information, making it unreadable, resulting in noise being
output. Lower the volume when scanning.
When playing a DTS format
LD there is audible noise on
the soundtrack. • Make sure that the input signal type is set to DIGITAL (see Choosing the input
signal on page 61).
Can’t record audio. • You can only make a digital recording from a digital source, and an analog
recording from an analog source.
• For digital sources, make sure that what you’re recording isn’t copy protected.
• Check that the
OUT jacks are properly connected to the recorders input jacks
(see Connecting other audio components on page 30).
Subwoofer output is very low. • To route more signal to the subwoofer, set it to PLUS or set the front speakers
to SMALL (see Speaker Setting on page 102).
Everything seems to be set up
correctly, but the playback
sound is odd. • The speakers may be out of phase. Check that the positive/negative speaker
terminals on the receiver are matched with the corresponding terminals on the
speakers (see Connecting the speakers on page 20).
The PHASE CONTROL
feature doesn’t seem to have
an audible effect.
• If applicable, check that the lowpass filter switch on your subwoofer is off, or
the lowpass cutoff is set to the highest frequency setting. If there is a
PHASE
setting on your subwoofer, set it to 0º (or depending on the subwoofer, the
setting where you think it has the best overall effect on the sound).
• Make sure the speaker distance setting is correct for all speakers (see Speaker
Distance on page 103).
Noise or hum can be heard
even when there is no sound
being input. • Check that personal computers or other digital components connected to the
same power source are not causing interference.
Can’t select some Input
functions by the
INPUT
SELECTOR on the front panel
or the
INPUT SELECT button
on the remote control.
• Check the Input Skip settings in the Input Setup menu.
• Check the HDMI Input assignment in the Input Setup menu then try OFF.
There seems to be a time lag
between the speakers and
the output of the subwoofer. • See Automatically conducting optimum sound tuning (Auto MCACC) on
page 39 to set up your system again using MCACC (this will automatically
compensate for a delay in the subwoofer output).
The maximum volume
available (shown in the front
panel display) is lower than
the
+12dB maximum.
• Check that the Volume Limit is set to OFF (see Volume Setup on page 106).
• The channel level setting may be over 0dB.
Symptom Remedy
VSX-1020_SYXCN.book 111 ページ ２０１０年３月１２日 金曜日 午前９時１０分