Pioneer VSX-920-K - Manual (Page 82)

Controlling the rest of your system 09
82
En
With Pioneer components, you don’t need to
program the power to switch off in a shutdown
sequence (except DVD recorders).
5 Repeat steps 3 to 4 to program a
sequence of up to five commands.
Programming mode will terminate
automatically when the 5 commands are
entered.
• If you press R.SETUP before programming
is completed, commands programmed up
to that point will be stored.
Using multi operations
1 Press MULTI OPERATION.
The LED flashes continuously.
2 Within five seconds, press an input
function button that has been set up with a
multi operation.
The receiver switches on (if it was in standby)
and the programmed multi operation is
performed automatically.
Using System off
1 Press MULTI OPERATION.
The LED flashes continuously.
2 Within five seconds, press  SOURCE.
The command sequence you programmed will
run, then all Pioneer components will switch
off
1 , followed by this receiver (switch of all the
zones becomes off).
Erasing the settings for the multi-
operation
This erases all the settings programmed in the
remote control for the multi-operation.
1 Press and hold R.SETUP, then press “8”
for three seconds.
The LED flashes continuously.
• To cancel the preset setup mode press
R.SETUP.
2 Press the input function button
containing the program you want to cancel or
the
 SOURCE button for three seconds.
If the LED lights for one second, the erasing
has been successfully completed.
Note
1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes
are sent.
VSX-1020_SYXCN.book 82 ページ ２０１０年３月１２日 金曜日 午前９時１０分